Cubot Z100 Pro Stock Firmware, Flash File Download

Cubot Z100 Pro Stock ROM MTK Backup Flash File

This Cubot Z100 Pro Firmware, Stock ROM can be used with any service tools capable of Flashing Stock ROM, flash file (MTK Backup) on Cubot Android devices.

Stock firmware are mostly needed to either upgrade your Cubot Z100 Pro or flash the phone to correct certain software issues or malfunctions on the phone. Here on this page I have contained the download link for the complete Cubot Z100 Pro Stock ROM, flash file which can be used to flash factory OS back to your Cubot Z100 Pro.

How to Download Stock Firmware and Flash Cubot Z100 Pro with this Stock ROM, Flash File

1. Download SP Flash Tool from here and install it on your PC. If you don't have MTK Android drivers installed on your PC yet, you must install it too. Download VCOM Drivers here

2. Download your Cubot Z100 Pro stock firmware, Flash File from here.

3. Open the SP Flash Tool you downloaded from the link above. It is compressed in a zip file, simply extract it onto a folder on your PC, open the folder to locate flash_tool.exe application and then; double-click it to lunch the program.

4. Go to the folder where you downloaded the Cubot Z100 Pro Stock ROM, flash file and open it. It is compressed in a ZIP File, simply decompress/unzip it onto a folder on your PC.

5. On SP Flash Tool, select Scatter Loading. A window should open. Using the browse button, navigate to the folder where you unzipped the Cubot Z100 Pro stock ROM and then select "MTXXXX-ANDROID-SCATTER", from there. Remember: "xxxx" refers to the MTK version of your phone.

6. Once selected, SP Flash Tool will load all the partitions in the Cubot Z100 Pro Stock ROM you downloaded. From the list, Mark all the partitions EXCEPT these three (3): Preloader, UserData and CACHE.

7. Now, select Download on SP Flash Tool.

8. Put off your Cubot Z100 Pro or remove battery from it and re-insert the battery again. Connect your Cubot Z100 Pro Mobile Phone to the PC and then tap the Power button once.

9. For few seconds, your Windows PC will install the necessary drivers for the flashing operation and then, the flashing operation will commence promptly.

10. When the flashing operation completes, SP Flash Tool will display a green PASS circle. You may then disconnect your phone from the PC.
CONGRATULATIONS! You have successfully flashed your Cubot Z100 Pro to its factory defaults.
NOTE: if you encounter any errors while flashing your Cubot Z100 Pro using SP Flash Tools, see here: Solutions to All SP Flash Tools Errors: Practical Guides

For Graphical Illustrations on how to flash Cubot android devices, see here: How to Flash Cubot Android Device: Step by Step with Pictures

Also Read: